Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chevrolet SSR StandardFACTORY OEM SERVICE PROCEDURE
Installation Procedure
WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the sealing surface of the BPMV with denatured alcohol, or equivalent, and a clean shop cloth.
- Ensure the motor connector (3) is in place on the EBCM (1).
- Install the EBCM to the BPMV. Use care when aligning the EBCM (1) to the BPMV electrical terminals (2).
- Install the 4 EBCM-to-BPMV retaining bolts. Tighten the bolts in a criss-cross pattern.
Tighten:Β
- First pass: Tighten the bolts to 3 N.m (27 lb in).
- Second pass: Tighten the bolts to 6 N.m (53 lb in).
- Connect the electrical connector to the EBCM (3). Ensure the cam (2) is secured by the lock tab.
- Connect the electrical connector to the brake fluid pressure sensor.
- Install the two BPMV bracket bolts.
Tighten:Β Tighten the bolts to 27 N.m (20 lb ft).
- Lower the vehicle.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (6.0L) or Battery Negative Cable Disconnection and Connection (7.0L) .
- If installing a replacement module, refer to Service Programming System (SPS) .
- If installing a replacement module, program the replacement module. Refer to Control Module References .
- Perform the Diagnostic System Check - Vehicle .
NOTE:
Refer to Fastener Notice
.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
