Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chevrolet SSR StandardFACTORY OEM SERVICE PROCEDURE
Electronic Brake Control Module (EBCM)
WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Electronic Brake Control Module (EBCM) Connector Parts Information
Connector Part Information
|
Terminal Part Information
|
Electronic Brake Control Module (EBCM) Connector Terminal Identification
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| A1 | L-BU | 830 | Wheel Speed Sensor Signal Left Front |
| A2 | YE | 873 | Left Front Wheel Speed Sensor Low Reference |
| A3 | D-GN | 872 | Wheel Speed Sensor Signal Right Front |
| A4 | TN | 833 | Wheel Speed Sensor Low Reference Right Front |
| A5 | TN | 884 | Wheel Speed Sensor Signal Left Rear |
| A6 | OG | 885 | Wheel Speed Sensor Low Reference Left Rear |
| A7 | BN | 882 | Wheel Speed Sensor Signal Right Rear |
| A8 | WH | 883 | Wheel Speed Sensor Low Reference Right Rear |
| A9-A14 | - | - | Not Used |
| A | RD/BK | 1442 | Battery Positive Voltage |
| B1-B8 | - | - | Not Used |
| B9 | TN | 2501 | High Speed GMLAN Serial Data (-) |
| B10 | TN | 2501 | High Speed GMLAN Serial Data (-) |
| B11 | TN/BK | 2500 | High Speed GMLAN Serial Data (+) |
| B12 | TN/BK | 2500 | High Speed GMLAN Serial Data (+) |
| B13 | L-BU | 2088 | Steering Wheel Position Sensor Low Reference |
| B14 | D-GN | 2087 | Steering Wheel Position Sensor 5-Volt Reference |
| B | RD/BK | 1442 | Battery Positive Voltage |
| C1-C5 | - | - | Not Used |
| C6 | L-BU | 1764 | Steering Wheel Position Signal B |
| C7 | L-GN | 1763 | Steering Wheel Position Signal A |
| C8 | D-BU | 716 | Yaw Rate Sensor Signal |
| C9 | L-GN/BK | 1338 | Lateral Accelerometer Signal |
| C10 | PU | 5002 | Brake Pressure Modulator Valve |
| C11-C14 | - | - | Not Used |
| C | PK | 1239 | Ignition 1 Voltage |
| D | - | - | Not Used |
| E | BK/WH | 251 | Ground |
| F | BK/WH | 251 | Ground |
| G | WH | 1294 | Variable Effort Steering Solenoid Supply Voltage |
| H | BN | 1295 | Variable Effort Steering Solenoid Control |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
