Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chevrolet SSR AutomaticFACTORY OEM SERVICE PROCEDURE
Section 122 (Disc Brake System)
WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Disc Brakes
- Brake Rotor Thickness Variation Measurement
- Brake Rotor Surface and Wear Inspection
- Brake Rotor Assembled Lateral Runout Measurement
- Brake Pad Inspection
- Brake Caliper Inspection
- Disc Brake Mounting and Hardware Inspection - Front
- Disc Brake Mounting and Hardware Inspection - Rear
- Repair Instructions
- Front Disc Brake Pads Replacement (JL9-J55)
- Front Disc Brake Pads Replacement (J56)
- Rear Disc Brake Pads Replacement (J56)
- Rear Disc Brake Pads Replacement (JL9-J55)
- Brake Pad and Rotor Burnishing
- Front Brake Caliper Replacement (J56)
- Front Brake Caliper Replacement (JL9-J55)
- Rear Brake Caliper Replacement (J56)
- Rear Brake Caliper Replacement (JL9-J55)
- Front Brake Caliper Overhaul (J56)
- Front Brake Caliper Overhaul (JL9-J55)
- Rear Brake Caliper Overhaul (JL9-J55)
- Rear Brake Caliper Overhaul (J56)
- Disc Brake Hardware Replacement - Front (J56)
- Disc Brake Hardware Replacement - Front (JL9-J55)
- Disc Brake Hardware Replacement - Rear (J56)
- Disc Brake Hardware Replacement - Rear (JL9-J55)
- Brake Caliper Bracket Replacement - Front
- Rear Brake Caliper Bracket Replacement
- Front Brake Rotor Replacement
- Rear Brake Rotor Replacement
- Brake Rotor Assembled Lateral Runout Correction
- Brake Rotor Assembled Lateral Runout Correction - Indexing
- Brake Rotor Assembled Lateral Runout Correction - Correction Plates
- Brake Rotor Assembled Lateral Runout Correction - On Vehicle Lathe
- Brake Rotor Refinishing
- Description and Operation
- Special Tools and Equipment
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
