2006 Chevrolet SSR AutomaticFACTORY OEM SERVICE PROCEDURE

Keyless Entry Personalization

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

The following items may be personalized through the DIC for Driver 1 or Driver 2:

  • Flash at unlock, Yes/No
  • Flash at lock, Yes/No
  • Fob reminder, On/Off
  • Passive door locking, Off/Silent/Horn
  • Passive door unlock, Driver/Both

Key fobs programmed for Driver 1 and Driver 2 can be programmed to recall personalization features. When the vehicle is accessed with the 3rd or 4th programmed fob, OPTIONS NOT AVAILABLE is displayed on the DIC. With the 3rd or 4th programmed fobs, personalization settings can be changed only for the ignition cycle. None of the personalization settings selected or changed can be recalled with the 3rd or 4th programmed key fob. Accessing the vehicle with any key fobs not programmed for Driver 1 or Driver 2 causes the OPTIONS NOT AVAILABLE message to display on the DIC. For more information on programming instructions and personalization, refer to the Owners Manual.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.