Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chevrolet SSR AutomaticFACTORY OEM SERVICE PROCEDURE
Installation Procedure
WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Position the yaw rate sensor in the vehicle (1).
- Install the yaw rate sensor bolts (2).
Tighten:Β Tighten the bolts to 7 N.m (62 lb in).
- Connect the yaw rate sensor electrical connector.
- Install the HVAC Control Module. Refer to HVAC Control Module Replacement .
- Install the IP accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
- Turn the ignition switch to the ON position, engine off.
- Perform the Diagnostic System Check - Vehicle .
NOTE:
Refer to Fastener Notice
.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
