Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chevrolet SSR AutomaticFACTORY OEM SERVICE PROCEDURE
Antilock Brake System Component Views
WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Head Up Display (HUD) (UV6) |
| 2 | Driver Information Center (DIC) Switch |
| 3 | Sunload Sensor Assembly |
| 4 | Hazard Switch |
| 5 | Radio |
| 6 | HVAC Control Module |
| 7 | I/P Compartment Lamp |
| 8 | Heated Seat Switch - Passenger |
| 9 | Suspension Control Switch |
| 10 | Auxiliary Power Outlet |
| 11 | Traction Control Switch |
| 12 | Cigar Lighter |
| 13 | Heated Seat Switch - Driver |
| 14 | Courtesy Lamp - Left |
| 15 | Ignition Mode Switch |
| 16 | Air Temperature Sensor - Inside |
| 17 | Inflatable Restraint Steering Wheel Module |
| 18 | Rear Compartment Lid Release Switch - Interior |
| 19 | Fuel Door Release Switch |
| 20 | I/P Dimmer Switch |
| 21 | Folding Top Control Switch (CM7) |
| 22 | Head Up Display (HUD) Switch (UV6) |
| 23 | Instrument Panel Cluster (IPC) |
| Callout | Component Name |
|---|---|
| 1 | Brake Pressure Modulator Valve (BPMV) |
| 2 | Brake Fluid Pressure Sensor |
| 3 | Brake Fluid Level Switch |
| 4 | Electronic Brake Control Module (EBCM) |
| 5 | Steering Angle Sensor |
| 6 | Brake Pedal Position Sensor |
| 7 | Yaw and Lateral Accelerometer Sensor |
| 8 | Park Brake Switch |
| Callout | Component Name |
|---|---|
| 1 | Wheel Speed Sensor (WSS)-LF |
| 2 | Wheel Speed Sensor (WSS)-LR |
| 3 | Wheel Speed Sensor (WSS)-RR |
| 4 | Wheel Speed Sensor (WSS)-RF |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
