Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chevrolet SSR AutomaticFACTORY OEM SERVICE PROCEDURE
Battery, Charging System And Starting System
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Code Index
- Diagnostic Starting Point - Engine Electrical
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- DTC P0562
- DTC P0563
- DTC P0621
- DTC P0622
- Symptoms - Engine Electrical
- Battery Inspection/Test (Non-HP2)
- Battery Charging
- Battery Electrical Drain/Parasitic Load Test (w/BCM)
- Battery Common Causes of Failure
- Jump Starting in Case of Emergency (Non HP2)
- Charging System Test
- Charge Indicator Always On
- Charge Indicator Inoperative
- Generator Noise Diagnosis
- Starter Solenoid Does Not Click
- Starter Solenoid Clicks, Engine Does Not Crank
- Engine Cranks Slowly
- Starter Motor Noise Diagnosis
- Repair Instructions
- Battery Negative Cable Disconnect/Connect Procedure
- Battery Negative Cable Replacement
- Battery Positive Cable Replacement (Battery To Junction Block)
- Battery Positive Cable Replacement (Junction Block To Engine)
- Battery Replacement
- Battery Tray Replacement
- Ground Strap Replacement
- Starter Motor Replacement
- Starter Shield Replacement
- Generator Bracket Replacement
- Generator Replacement
- Description and Operation
- Special Tools and Equipment
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.