SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSSTATIONARY WINDOW SYSTEMREPAIR INSTRUCTIONSWINDSHIELD REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet SSR Automatic

Removal Procedure

2006 Chevrolet SSR AutomaticSECTION Removal Procedure
    IMPORTANT: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
  1. Open the hood.
    2. CAUTION: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
  2. Cover and protect the following parts from broken glass:
    • The upper dash pad
    • The defroster outlets and A/C outlets
    • The seats and carpeting
  3. Disconnect the antenna cable. Refer to Antenna Cable Replacement in Entertainment.
  4. Remove the windshield wiper arms. Refer to Wiper Arm Replacement in Wipers/Washer Systems.
  5. Remove the cowl air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  6. Remove the windshield frame appliques. Refer to Applique Replacement - Windshield Frame in Exterior Trim.
  7. Remove the rearview mirror. Refer to Rearview Mirror Replacement .
    8. Fig 1: Identifying Upper Reveal Molding from Windshield
    GM105242Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.