SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSDOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEMREPAIR INSTRUCTIONSWINDOW REGULATOR REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet SSR Automatic

Removal Procedure

2006 Chevrolet SSR AutomaticSECTION Removal Procedure
  1. Remove the side front door trim panel. Refer to Trim Panel Replacement - Door .
    2. Fig 1: View Of Inner Door Panel Protector
    GM1275116Courtesy of GENERAL MOTORS CORP.
  2. Remove the front door water deflector. Refer to Water Deflector Replacement - Front Door .
  3. Remove the door window. Refer to Window Replacement - Door .
    4. Fig 2: View of Regular Motor Electrical Connector
    GM1325786Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the window regulator electrical connector.
    5. Fig 3: View of Window Regulator Assembly
    GM1325781Courtesy of GENERAL MOTORS CORP.
  5. Remove the nuts from the window regulator.
  6. Remove the window regulator assembly from the door by folding both sides together.
    7. Fig 4: Removing Regulator Through Opening in Door
    GM1325783Courtesy of GENERAL MOTORS CORP.
  7. Remove the regulator from the door through the opening in the door.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.