2006 Chevrolet Optra5 LS, StandardFACTORY OEM SERVICE PROCEDURE

Automatic Transmission Shift Lock Control Connector End Views

Automatic Transmission Shift Lever (North America)

GM1467039Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • KET MG 610396
  • 4-Way F Series Sealed (WH)
Pin Wire Color Circuit No. Function
1 BK 1050 Ground
2 L-GN 275 Park/Neutral Position (PNP) Switch Signal
3 D-GN 286 Shift Lock Control Solenoid
4 PK 239 Ignition 1 Voltage
Automatic Transmission Shift Lever (Except North America)

GM1467039Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • KET MG 610396
  • 4-Way F Series Sealed (WH)
Pin Wire Color Circuit No. Function
1 BK 1050 Ground
2 L-GN 275 Park/Neutral Position (PNP) Switch Signal
3 L-GN 275 Park/Neutral Position (PNP) Switch Signal
4 D-GN 286 Automatic Transmission Shift Lock Solenoid Supply Voltage
Key Interlock Module (North America)

GM1333956Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • AK 36915
  • 9-Way F Relay (BK)
Pin Wire Color Circuit No. Function
1 - - Not Used
2 YE 43 Accessory Voltage
3 - - Not Used
4 D-GN 286 Shift Lock Control Solenoid Control
5 YE 1075 Park Neutral Position (PNP) Switch Signal
6 BK 250 Ground
7 L-BU 20 Stop Lamp Switch Signal
8 L-GN 275 Park Neutral Position (PNP) Switch Signal
9 - - Not Used
Key Interlock Module (Except North America)

GM1333956Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • AK 36905
  • 9-Way F Relay (BK)
Pin Wire Color Circuit No. Function
1 - - Not Used
2 YE 1075 Park Neutral Position (PNP) Switch Signal
3 - - Not Used
4 BK 250 Ground
5 D-GN 286 Shift Lock Control Solenoid Control
6 L-GN 275 Park Neutral Position (PNP) Switch Signal
7 OG/BK 434 Park Neutral Position (PNP) Switch Signal
8 L-BU 20 Stop Lamp Switch Signal
9 YE 434 Park Neutral Position (PNP) Switch Signal
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.