Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chevrolet Impala SSFACTORY OEM SERVICE PROCEDURE
Turn Signal/Multifunction Switch C2
WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Lighting Systems Connector End Views
Connector Part Information
|
Terminal Part Information
|
Turn Signal/Multifunction Switch C2
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| A | YE | 307 | Flash to Pass Switch Signal |
| B-C | - | - | Not Used |
| D | BK | 350 | Ground |
| E | PU | 524 | Headlamp Switch Highbeam Signal |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.