Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2006 Chevrolet Impala SSFACTORY OEM SERVICE PROCEDURE

Removal Procedure

IMPORTANT: Always maintain cleanliness when servicing fuel system components.

Fig 1: Disconnecting The Fuel Level Sensor Electrical Connector

GM1575965

Courtesy of GENERAL MOTORS CORP.

Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
Disconnect the fuel level sensor electrical connector (1).

Fig 2: Push In The Fuel Level Sensor Retainer

GM1575966

Courtesy of GENERAL MOTORS CORP.

Push in the fuel level sensor retainer (1).

Fig 3: Slide The Fuel Level Sensor Downward And Off Of The Bucket

GM1575967

Courtesy of GENERAL MOTORS CORP.

Slide the fuel level sensor (1) downward and off of the bucket.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.