2006 Chevrolet HHR LS, AutomaticFACTORY OEM SERVICE PROCEDURE

Remote Control Door Lock Receiver Replacement

WARNING: This page is about a different car, the 2005 Pontiac Pursuit and 2005 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remote Control Door Lock Receiver Replacement
GM1549892Courtesy of GENERAL MOTORS CORP.
Remote Control Door Lock Receiver Replacement

Callout Component Name
Preliminary Procedure:Β 
Remove the instrument panel (I/P) upper pad. Refer to Trim Panel Replacement - Instrument Panel (I/P) Upper .
1 Module, Remote Keyless Entry
Tip:Β  Disconnect the electrical connector.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.