Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chevrolet Venture LSFACTORY OEM SERVICE PROCEDURE
Removal Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the left instrument panel sound insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
- Remove the accelerator cable (5) from the accelerator pedal (1).
- Install a piece of mechanics wire to the accelerator cable to aid in the installation of the new cable.
- Squeeze the accelerator cable cover tangs and push the accelerator cable through the cowl.
- Remove the accelerator cable shield, if equipped.
- Remove the accelerator cable from the retaining clip.
- Remove the cruise control cable from the throttle body lever.
- Remove the cruise control cable from the accelerator cable bracket.
- Remove the accelerator cable from the throttle body lever.
- Remove the accelerator cable from the accelerator cable bracket.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.