Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2005 Chevrolet Venture LSFACTORY OEM SERVICE PROCEDURE

Removal Procedure

Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
Remove the right side instrument panel (I/P) insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages, and Console.

Fig 1: View Of Body Control Module

Courtesy of GENERAL MOTORS CORP.

Push the release tab on the bottom of the bracket to release the body control module (BCM).
Slide the BCM from the bracket.

Fig 2: View Of Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connectors.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.