WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Remote Control Door Lock Receiver

Courtesy of GENERAL MOTORS CORP.

REMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT

Callout	Component Name
NOTE: Refer to FASTENER NOTICE in Cautions and Notices. Fastener Tightening Specifications: Refer to FASTENER TIGHTENING SPECIFICATIONS .
1	Plate Assembly, Instrument Panel (I/P) Tip: Remove the I/P accessory trim plate. Refer to TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY .
2	Screws, Remote Control Door Lock Receiver Bracket (Qty: 3) Tighten: 3 N.m (27 lb in)
3	Bracket, Remote Control Door Lock Receiver
4	Receiver, Remote Control Door Lock Tip: Release the retaining clips to remove the receiver from the bracket. Reprogram the receiver. Refer to REMOTE CONTROL DOOR LOCK RECEIVER PROGRAMMING & SETUP (DOMESTIC, CANADA & JAPAN) or REMOTE CONTROL DOOR LOCK RECEIVER PROGRAMMING & SETUP (EXPORT) in Programming and Setup.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Remote Control Door Lock Receiver Replacement

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?