Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chevrolet SSR AutomaticFACTORY OEM SERVICE PROCEDURE
Removal Procedure
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition OFF.
- Remove the cruise control module to bracket bolts leaving the bracket attached to the frame rail.
- Remove the cruise control throttle cable clip attached to the front of the dash.
- Pull the cruise control module up behind the power brake booster.
- Disconnect the cruise control module harness connector.
- Cruise Control Throttle Cable (1)
- Cable Snap (3)
- Cable End (4)
- Disconnect the cruise control throttle cable snap from the throttle body cam.
- Unclip the cruise control throttle cable from both attachment clips.
- Disconnect the cruise control throttle cable from the module by rotating the cable 1/4 turn counter-clockwise at the module.
- Remove the cable from the connecting strap.
- Remove and discard the cut cruise control throttle cable and replace with an adjustable cruise control throttle cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.