2005 Chevrolet Monte Carlo LSFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: View Of Ignition Coil Module And Module Mounting Bracket
    GM12299Courtesy of GENERAL MOTORS CORP.
  1. Install the ICM to the module mounting bracket.
  2. Install the ignition coils (2) to the ICM (3).
  3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the ignition coil screws (1).

    Tighten:Β  Tighten the screws to 4.5 N.m (40 lb in).

  5. Fig 2: View Of Spark Plug Wire Connections To Ignition Coils
    GM15977Courtesy of GENERAL MOTORS CORP.
  6. Connect the spark plug wires as noted during the removal.
  7. Connect the ICM electrical connectors.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.