2005 Chevrolet Equinox LS, FWDFACTORY OEM SERVICE PROCEDURE

Fastener Tightening Specifications

Fastener Tightening Specifications

Application Specification
Metric English
Accelerator Pedal Position Sensor Bolt 25 N.m 25 lb ft
Air Cleaner Assembly Bolt 10 N.m 89 lb in
Air Cleaner Intake Duct Clamp 4 N.m 35 lb in
Camshaft Position Sensor Bolt 10 N.m 89 lb in
Camshaft Position Sensor Nut 11 N.m 97 lb in
Engine Coolant Temperature Sensor 23 N.m 17 lb ft
Evaporative Emissions (EVAP) Canister Purge Valve Bolt 10 N.m 89 lb in
EVAP Canister to Underbody Nut 9 N.m 80 lb ft
EVAP Hose/Pipe to Strut Tower Nut 10 N.m 89 lb in
Exhaust Gas Recirculation (EGR) Pipe to EGR Valve Bolt 30 N.m 22 lb ft
EGR Pipe to Exhaust Manifold Bolt 10 N.m 89 lb in
EGR Valve Bolt 30 N.m 22 lb ft
Fuel Filler Tube Bolt 12 N.m 106 lb in
Fuel Filler Tube Clamp 5 N.m 44 lb in
Fuel Hose/Pipe Retainer Nut 28 N.m 21 lb ft
Fuel Rail Bolt 10 N.m 89 lb in
Fuel Tank Strap Bolt 25 N.m 18 lb ft
Heated Oxygen Sensor (HO2S) 1 42 N.m 31 lb ft
Heated Oxygen Sensor (HO2S) 2 42 N.m 31 lb ft
Heater Outlet Pipe to Upper Intake Manifold Nut 25 N.m 18 lb ft
Ignition Coil/Control Module to Bracket 4.5 N.m 40 lb ft
Ignition Control Module Bracket Bolt 25 N.m 18 lb ft
Ignition Control Module Bracket Nut 25 N.m 18 lb ft
Knock Sensor Bolt 25 N.m 18 lb ft
Manifold Absolute Pressure Sensor Bolt 10 N.m 89 lb in
Mass Air Flow Sensor Screw 4 N.m 35 lb in
Positive Crankcase Ventilation Fresh Air Tube Retainer Bolt 5 N.m 44 lb in
Propeller Shaft Guard Bolt 25 N.m 18 lb ft
Spark Plug - Initial Installation 20 N.m 15 lb ft
Spark Plug - After Initial Installation 15 N.m 11 lb ft
Throttle Body Bolt 10 N.m 89 lb in
Throttle Body Stud 6 N.m 53 lb in
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.