2005 Chevrolet Equinox LS, FWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: View Of Ignition Control Module Bracket & Components
    GM1087898Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition control module bracket.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the ignition control module bracket nuts (6).

    Tighten:Β  Tighten the nuts to 25 N.m (18 lb ft).

  4. Install the ignition control module bracket bolts (2).

    Tighten:Β  Tighten the bolts to 25 N.m (18 lb ft).

  5. Fig 2: View Of Heater Outlet Pipe
    GM1087631Courtesy of GENERAL MOTORS CORP.
  6. Install the nut (1) retaining the heater outlet pipe.

    Tighten:Β  Tighten the nut to 25 N.m (18 lb ft).

  7. Fig 3: View Of Ignition Control Module Bracket & Components
    GM1087898Courtesy of GENERAL MOTORS CORP.
  8. Install the engine wire harness retainers to the ignition control module bracket studs (5).
  9. Install the bolt (3) from the fuel injector wire harness bracket (4) and PCV valve fresh air tube retainer.

    Tighten:Β  Tighten the bolts to 5 N.m (44 lb in).

  10. Install the ignition coil/control module to the ignition control module bracket.
  11. Install the 4 bolts securing the ignition coil/control module to the ignition control module bracket.

    Tighten:Β  Tighten the bolts to 4.5 N.m (40 lb in).

  12. Install the spark plug wire retainer (1) to the ignition control module bracket.
  13. Connect the ignition coil/control module electrical connectors.
  14. Install the injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 3.4L.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.