Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chevrolet Equinox LS, FWDFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- If the fuel level sending unit is being replaced, install the fuel level sending unit onto the new fuel pump. Refer to Fuel Level Sensor Replacement - Primary .
- Insert the new primary fuel pump module assembly with the level sender and the new fuel pump-to-tank seal. Ensure the orientation tabs are aligned.
- Use the J 45722 to install the fuel pump lock ring. See Special Tools .
- Connect the wiring harness to the primary fuel pump module and fuel tank pressure sensor.
- Install the secondary fuel pump module. Refer to Fuel Tank Module Replacement - Secondary .
- Install the fuel tank. Refer to Fuel Tank Replacement (FWD) or Fuel Tank Replacement (AWD) .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
