Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chevrolet Equinox LS, FWDFACTORY OEM SERVICE PROCEDURE
Powertrain Control Module (PCM) Connectors
Powertrain Control Module (PCM) C1 Connector End View
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| 1 | TN/BK | 2500 | High Speed GMLAN Serial Data (+) |
| 2 | TN | 2501 | High Speed GMLAN Serial Data (-) |
| 3 | - | - | Not Used |
| 4 | GY | 2700 | 5-Volt Reference |
| 5 | - | - | Not Used |
| 6 | BN/WH | 419 | MIL Control |
| 7 | TN | 5514 | Low Reference |
| 8-9 | - | - | Not Used |
| 10 | WH | 1310 | EVAP Canister Vent Solenoid Control |
| 11 | - | - | Not Used |
| 12 | TN | 2759 | Low Reference |
| 13-17 | - | - | Not Used |
| 18 | YE | 743 | Accessory Voltage |
| 19 | PK | 639 | Ignition 1 Voltage |
| 20 | RD/WH | 1440 | Battery Positive Voltage |
| 21 | - | - | Not Used |
| 22 | BN | 818 | VSS Signal |
| 23 | YE | 447 | Starter Relay Coil Control |
| 24 | BN | 5069 | Engine Main Relay Coil Control |
| 25 | - | - | Not Used |
| 26 | D-GN | 890 | Fuel Tank Pressure Sensor Signal |
| 27-30 | - | - | Not Used |
| 31 | OG/BK | 380 | A/C Refrigerant Pressure Sensor Signal |
| 32 | L-BU | 20 | Stop Lamp Supply Voltage |
| 33 | D-GN/WH | 459 | A/C Compressor Clutch Relay Control |
| 34-36 | - | - | Not Used |
| 37 | D-GN/WH | 465 | Fuel Pump Primary Relay Control |
| 38 | OG/BK | 1786 | Transmission Park/Neutral Signal |
| 39-42 | - | - | Not Used |
| 43 | PU | 1589 | Primary Fuel Level Sensor Signal |
| 44 | GY | 1884 | Cruise Control Set/Coast/Resume/Accelerate Switch Signal |
| 45 | - | - | Not Used |
| 46 | PU | 420 | Torque Converter Clutch Brake Switch Signal |
| 47 | - | - | Not Used |
| 48 | D-GN | 335 | Low Speed Cooling Fan Relay Control |
| 49 | - | - | Not Used |
| 50 | D-BU | 473 | High Speed Cooling Fan Relay Control |
| 51-52 | - | - | Not Used |
| 53 | GY | 2709 | Fuel Tank Pressure Sensor 5-Volt Reference |
| 54-56 | - | - | Not Used |
Powertrain Control Module (PCM) C2 Connector End View
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| 1 | BN | 1456 | Exhaust Gas Recirculation Valve Position Signal |
| 2 | TN | 800 | UART Serial Data 1 |
| 3 | OG/BK | 1061 | UART Serial Data 2 |
| 4 | PK/BK | 1746 | Fuel Injector Control 3 |
| 5 | TN | 1744 | Fuel Injector Control 1 |
| 6 | L-GN/BK | 1745 | Fuel Injector Control 2 |
| 7 | TN/WH | 845 | Fuel Injector Control 5 |
| 8 | TN | 2753 | Exhaust Gas Recirculation Sensor Low Reference |
| 9 | YE/BK | 846 | Fuel Injector Control 6 |
| 10 | L-BU/BK | 844 | Fuel Injector Control 4 |
| 11 | OG/WH | 2122 | IC 2 Control |
| 12 | GY/WH | 3113 | Heated Oxygen Sensor Heater Low Control Bank 1 Sensor 1 |
| 13 | OG | 1676 | Exhaust Gas Recirculation Solenoid Supply Voltage |
| 14 | - | - | Not Used |
| 15 | PU | 574 | Low Reference |
| 16 | GY | 435 | Exhaust Gas Recirculation Solenoid Control |
| 17 | - | - | Not Used |
| 18 | L-GN | 432 | Manifold Absolute Pressure Sensor Signal |
| 19-20 | - | - | Not Used |
| 21 | OG | 631 | Camshaft Sensor 12-Volt Reference |
| 22 | L-GN | 1867 | Crankshaft Position Sensor 12-Volt Reference |
| 23-25 | - | - | Not Used |
| 26 | BN/WH | 633 | Camshaft Position Sensor Signal |
| 27 | L-BU/BK | 647 | Medium Resolution Engine Speed Signal |
| 28-29 | - | - | Not Used |
| 30 | OG/BK | 469 | Manifold Absolute Pressure Sensor Low Reference |
| 31 | - | - | Not Used |
| 32 | PK/BK | 632 | Camshaft Position Sensor Low Reference |
| 33 | GY | 5047 | Exhaust Gas Recirculation 5-Volt Reference |
| 34 | GY | 2704 | 5-Volt Reference |
| 35 | - | - | Not Used |
| 36 | GY | 2303 | Knock Sensor Low Reference 2 |
| 37 | YE | 2174 | Ignition Control Timing Low Reference 1 |
| 38 | D-BU | 496 | Knock Sensor Signal 1 |
| 39 | BK/WH | 1251 | Ground |
| 40 | GY | 1716 | Knock Sensor Low Reference 1 |
| 41 | D-GN/WH | 428 | EVAP Canister Purge Solenoid Control |
| 42-46 | - | - | Not Used |
| 47 | TN/WH | 1653 | HO2S 1 Low Signal |
| 48 | PU/WH | 1665 | HO2S 1 High Signal |
| 49-52 | - | - | Not Used |
| 53 | OG | 225 | Generator Turn On Signal |
| 54 | L-BU | 1876 | Knock Sensor Signal 2 |
| 55 | YE | 410 | Engine Coolant Temperature Sensor Signal |
| 56 | BK/WH | 1351 | Ground |
| 57 | TN/BK | 231 | Oil Pressure Switch Signal |
| 58-60 | - | - | Not Used |
| 61 | PU | 2121 | IC 1 Control |
| 62 | - | - | Not Used |
| 63 | L-BU | 2123 | Ignition Control 3 |
| 64-72 | - | - | Not Used |
| 73 | BK/WH | 451 | Ground |
Powertrain Control Module (PCM) C3 Connector End View
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| 1-3 | - | - | Not Used |
| 4 | TN/WH | 1669 | HO2S 2 Low Signal |
| 5 | - | - | Not Used |
| 6 | YE | 492 | Mass Air Flow Sensor Signal |
| 7 | - | - | Not Used |
| 8 | GY/WH | 3122 | HO2S 2 Heater Low Control |
| 9-18 | - | - | Not Used |
| 19 | PU/WH | 1668 | HO2S 2 High Signal |
| 20-25 | - | - | Not Used |
| 26 | TN | 472 | Intake Air Temperature Sensor Signal |
| 27-49 | - | - | Not Used |
| 50 | TN | 2760 | Intake Air Temperature Sensor Low Reference |
| 51-56 | - | - | Not Used |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
