Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chevrolet Equinox LS, AWDFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Install the throttle body studs if previously removed.
Tighten:Β Tighten the throttle body stud to 6 N.m (53 lb in).
- Install the throttle body (1) to the intake manifold
- Install the throttle body bolts.
Tighten:Β Tighten the throttle body-to-intake manifold bolts to 10 N.m (89 lb in).
- Connect the TAC module electrical connector (1) to the TAC module (3) then press down the connector lock (2) in order to secure the TAC module electrical connector.
- Install the heater outlet pipe. Refer to Heater Pipe Replacement - Outlet in Engine Cooling.
- Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct ReplacementΒ .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
