Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chevrolet Equinox LS, AWDFACTORY OEM SERVICE PROCEDURE
Engine Controls Component Views
| Callout | Component Name |
|---|---|
| 1 | Engine Harness |
| 2 | Underhood Fuse Block C1 |
| 3 | Powertrain Control Module (PCM) |
| Callout | Component Name |
|---|---|
| 1 | Exhaust Gas Recirculation (EGR) Valve |
| 2 | Throttle Actuator Control (TAC) Module |
| 3 | Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor |
| 4 | Evaporative Emissions (EVAP) Canister Purge Solenoid |
| 5 | Generator |
| 6 | C150 |
| 7 | Heated Oxygen Sensor (HO2S) 1 |
| 8 | Engine Coolant Temperature (ECT) Sensor |
| 9 | Ignition Control Module (ICM) |
| 10 | Manifold Absolute Pressure (MAP) Sensor |
| Callout | Component Name |
|---|---|
| 1 | Fuel Injector 2 |
| 2 | Fuel Injector 1 |
| 3 | Fuel Injector 3 |
| 4 | Fuel Injector 5 |
| 5 | Fuel Injector 4 |
| 6 | Fuel Injector 6 |
| Callout | Component Name |
|---|---|
| 1 | Camshaft Position (CMP) Sensor |
| 2 | Belt |
| Callout | Component Name |
|---|---|
| 1 | Knock Sensor (KS) 1 |
| 2 | Crankshaft Position (CKP) Sensor |
| 3 | G107 Lead |
| Callout | Component Name |
|---|---|
| 1 | A/C Compressor Clutch |
| 2 | A/C Refrigerant Pressure Sensor |
| 3 | Knock Sensor (KS) 2 |
| 4 | Engine Oil Pressure (EOP) Switch |
| 5 | Starter Motor Leads |
| Callout | Component Name |
|---|---|
| 1 | G105 |
| 2 | Park/Neutral Position (PNP) Switch |
| 3 | A/T Input Speed Shaft (ISS) Sensor |
| 4 | A/T Output Speed Shaft (OSS) Sensor |
| 5 | C100 |
| Callout | Component Name |
|---|---|
| 1 | Accelerator Pedal Position (APP) Sensor |
| 2 | Accelerator Pedal Bracket |
| Callout | Component Name |
|---|---|
| 1 | Evaporative Emissions (EVAP) Canister Vent Solenoid |
| Callout | Component Name |
|---|---|
| 1 | Fuel Tank Pressure (FTP) Sensor Connector |
| 2 | Fuel Pump and Sender Assembly Connector - Primary |
| 3 | Fuel Pump |
| 4 | Lead - Primary Sender to Secondary Sender Assembly |
| 5 | Fuel Level Sensor |
| 6 | Fuel Pump and Sender Assembly Connector - Secondary |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
