Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chevrolet Epica LSFACTORY OEM SERVICE PROCEDURE
Engine Controls Component Views
Fig 1: View Of Vehicle Speed Sensor (VSS), Throttle Position (TP) Sensor And Engine Control Module (ECM)
| Callout | Component Name |
|---|---|
| 1 | Vehicle Speed Sensor (VSS) |
| 2 | Throttle Position (TP) Sensor |
| 3 | Engine Control Module (ECM) (Euro Emissions) |
| Callout | Component Name |
|---|---|
| 1 | Idle Air Control (IAC) Valve |
| 2 | Manifold Absolute Pressure (MAP) Sensor 2.0L |
| Callout | Component Name |
|---|---|
| 1 | Camshaft Position (CMP) Sensor |
| 2 | Crankshaft Position (CKP) Sensor |
| 3 | EVAP Canister Purge Solenoid Valve |
Fig 4: View Of Intake Air Temperature (IAT), Engine Coolant Temperature (ECT) Sensors And Exhaust Gas Recirculation (EGR) Valves
| Callout | Component Name |
|---|---|
| 1 | Exhaust Gas Recirculation (EGR) Valve 2.0L |
| 2 | Intake Air Temperature (IAT) Sensor |
| 3 | Engine Coolant Temperature Sensor (ECT) 2.0L |
| Callout | Component Name |
|---|---|
| 1 | Fuel Injector 1 (2.0L) |
| 2 | Fuel Injector 2 (2.0L) |
| 3 | Fuel Injector 3 (2.0L) |
| 4 | Fuel Injector 4 (2.0L) |
| 5 | Oxygen Sensor (O2S) |
| 6 | Oil Pressure Switch |
| Callout | Component Name |
|---|---|
| 1 | Rough Road Sensor |
| 2 | Fuel Pump |
| Callout | Component Name |
|---|---|
| 1 | Heated Oxygen Sensor (HO2S) |
| 2 | Knock Sensor (KS) |
| Callout | Component Name |
|---|---|
| 1 | Ignition Coil Module |
| Callout | Component Name |
|---|---|
| 1 | Engine Control Module (ECM) 2.0L |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
