Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chevrolet Cobalt SSFACTORY OEM SERVICE PROCEDURE
Power Steering System Component Views
| Callout | Component Name |
|---|---|
| 1 | Turn Signal/Multifunction Switch |
| 2 | Inflatable Restraint Steering Wheel Module Coil |
| 3 | Windshield Wiper/Washer Switch |
| 4 | Steering Wheel |
| 5 | Steering Wheel Controls - Right (UK3) |
| 6 | Horn Switch |
| 7 | Steering Wheel Controls - Left (UK3) |
| 8 | Electronic Power Steering Control Module (EPS) |
| 9 | Electronic Power Steering (EPS) Control Motor |
| 10 | Ignition Switch |
| 11 | Ignition Lock Cylinder Control Solenoid (MN5) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.