2005 Chevrolet ClassicFACTORY OEM SERVICE PROCEDURE

Front Toe Adjustment

    Fig 1: View Of Tie Rod Jam Nut & Adjuster
    GM564010Courtesy of GENERAL MOTORS CORP.
  1. Ensure that the steering wheel is set in a straight ahead position.
  2. Loosen the tie rod jam nut (5).
  3. Adjust the toe to specification by turning the adjuster (6). Refer to Wheel Alignment SpecificationsΒ .
  4. Install the tie rod jam nut (5).

    Tighten:Β  Tighten the tie rod jam nut (5) to 68 N.m (50 lb ft).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.