Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chevrolet ClassicFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Install the fuel pipes (1).
- Position the fuel pipes in the body clips.
- Install the fuel pipe mounting bolts into the body clips.
Tighten:Β Tighten the bolts to 6 N.m (53 lb in).
- Install the exhaust heat shield.
Tighten:Β
- Tighten the exhaust shield bolt to 2 N.m (18 lb in).
- Tighten the exhaust shield nuts to 1 N.m (9 lb in).
- Remove the caps on the fuel pipes.
- Connect the quick-connect fittings at the fuel sender pipes. Refer to Quick Connect Fitting(s) Service (Plastic Collar)Β .
- Lower the vehicle.
- Connect the quick-connect fittings at engine compartment fuel feed and return pipes. Refer to Quick Connect Fitting(s) Service (Metal Collar)Β
- Connect the negative battery cable.
- Inspect for fuel leaks using the following procedure:
- Turn ON the ignition, with the engine OFF for 2 seconds.
- Turn OFF the ignition for 10 seconds.
- Turn ON the ignition, with the engine OFF.
- Inspect for fuel leaks.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
