Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chevrolet Astro Van Cargo, RWDFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Install the MFI fuel meter body into the bracket on the lower intake manifold. Place all of the fuel tubes in a forward position. Route the number 3 fuel tube behind the numbers 1 and 5 fuel tubes.
CAUTION:
Verify that the injectors are firmly seated and locked in their casting sockets, in order to reduce the risk of fire and personal injury. An unlocked or a loose injector could work loose from its socket and produce a fuel leak. If an injector is loose, replace the retainer.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.