Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chevrolet Venture LT, AWDFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Remove the fastener from the coolant tank.
- Remove the coolant tank and set aside.
- Remove the 3 bolts from the support brace and remove the brace.
- Disconnect the mass air flow (MAF) sensor electrical connector.
- Loosen the 2 clamps on the AIR intake duct/MAF sensor assembly.
- Remove the air inlet duct/MAF sensor assembly (1).
- Unsnap the 2 latches and remove the air cleaner housing cover (2).
- Remove the air filter element (3).
- Unsnap the latch on the upper cover and remove the cover.
- Carefully remove the powertrain control module (PCM) leaving the 2 harnesses connected and set aside.
- Remove the 2 bolts (2) from the air cleaner assembly and remove the housing.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.