2004 Chevrolet Venture Base, Van Cargo ExtendedFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. Remove the caps from the fuel pipes.
    Fig 1: View Of Fuel Return Pipe
    GM22507Courtesy of GENERAL MOTORS CORP.
  2. Lubricate the new O-ring with clean engine oil.
  3. Install the O-ring and the engine fuel return pipe to the fuel pressure regulator.
  4. Fig 2: Identifying Engine Fuel Feed Pipe
    GM22505Courtesy of GENERAL MOTORS CORP.
  5. Lubricate the new O-ring with clean engine oil.
  6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the O-ring and the engine fuel feed pipe to the fuel rail.

    Tighten:Β  Tighten the engine fuel pipe fittings to 17 N.m (13 lb ft).

  8. Install the upper intake manifold assembly. Refer to Intake Manifold Replacement - Upper in Engine Mechanical.
  9. Fig 3: View Of Quick-Connect Fittings
    GM49740Courtesy of GENERAL MOTORS CORP.
  10. Connect the quick-connect fittings in the engine compartment. Refer to Quick Connect Fitting(s) Service (Metal Collar)Β .
  11. Tighten the fuel filler cap.
    1. Turn ON the ignition for 2 seconds.
    2. Turn OFF the ignition for 10 seconds.
    3. Turn ON the ignition.
    4. Inspect for fuel leaks.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.