2004 Chevrolet Venture Base, Van Cargo ExtendedFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: View Of EGR Valve
    GM507392Courtesy of GENERAL MOTORS CORP.
  1. Install the EGR valve with a new gasket to the intake manifold.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolts through the EGR valve.

    Tighten:Β  Tighten the bolts to 30 N.m (22 lb ft).

  4. Connect the pipe assembly to the EGR valve.
  5. Install the bolt.

    Tighten:Β  Tighten the bolts to 25 N.m (18 lb ft).

  6. Install the transaxle fluid filler tube. Refer toFiller Tube and Seal Replacement .
  7. Connect the EGR valve electrical connector.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.