Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chevrolet Venture Base, Van Cargo ExtendedFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Loosen the 2 intake air duct clamps (1) from the mass airflow (MAF) sensor (2) and the throttle body.
- Remove the intake air temperature (IAT) sensor from the duct. Refer to Intake Air Temperature (IAT) Sensor Replacement .
- Disconnect the vent tube from the air intake duct.
- Disconnect the MAF sensor electrical connector.
- Unlatch the air cleaner cover clips (1) and remove the air intake duct and air cleaner cover.
- Separate the air intake duct from the MAF sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.