Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chevrolet Tracker RWDFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Route the interlock cable under the carpet to the manual selector and under the instrument panel to the ignition switch.
- Place the manual selector lever in the NEUTRAL position.
- Turn the ignition switch to ACC.
- Install the interlock cable end to the ignition switch (1).
- Secure the interlock cable end with the bracket retaining screw.
- Adjust and tighten the screw in order to get the correct tension.
- Install the steering column upper cover and the steering column lower cover to the steering column.
- Secure the covers to the steering column with the screws.
- Install the interlock cable end.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.