2004 Chevrolet Tracker RWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. Install the EGR pipe (4) with a new upper gasket (2) and a new lower gasket (7) to the intake manifold.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Secure the EGR pipe (4) to the upper intake manifold with the 2 fasteners (3).

    Tighten:Β  Tighten the fasteners to 15 N.m (11 lb ft).

  4. Secure the EGR pipe (4) to the lower intake manifold with the 2 fasteners (6).

    Tighten:Β  Tighten the fastener to 10 N.m (89 lb in).

  5. Install the fastener (5) to the EGR pipe bracket.

    Tighten:Β  Tighten the fastener to 10 N.m (89 lb in).

  6. Start the engine and check for exhaust leaks.
  7. Repair as necessary.
  8. Fig 1: View Of EGR Valve Pipe & Components
    GM615485Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.