Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chevrolet Tracker RWDFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS LOCATION
| Component | Location |
|---|---|
| G100 | Right rear side of engine compartment, near battery. |
| G101 | Right side of engine compartment, lower rear side of engine. |
| G102 | Left rear of cylinder head. |
| G103 | Right rear of engine compartment, mounted to intake manifold. |
| G104 | Left front of core support, near washer reservoir. See Figure . |
| G105 | Right front of core support, near horn. See Figure . |
| G200 | Behind left side of dash, above junction block. See Figure . |
| G201 | Behind right side of dash, near blower assembly. |
| G202 | Under center console, forward of shifter. |
| G400 | Inside rear door, near license plate lamps. See Figure . |
| G401 | Rear door harness, near rear wiper motor. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.