Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2004 Chevrolet Tracker RWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

Install the accelerometer (1) to the vehicle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the two bolts (2) that retain the accelerometer.
Tighten: Tighten the two accelerometer bolts to 16 N.m (12 lb ft).

Fig 1: View Of Accelerometer & Bolts

Courtesy of GENERAL MOTORS CORP.

Connect the accelerometer electrical connector (2).

Fig 2: View Of Accelerometer Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Install the parking brake lever bezel (1).
Install the parking brake lever bezel attaching screws (2).
Perform Diagnostic System Check - ABS .

Fig 3: View Of Parking Brake Lever Bezel & Screws

Courtesy of GENERAL MOTORS CORP.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.