Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chevrolet Tracker RWDFACTORY OEM SERVICE PROCEDURE
ABS Component Views
| Callout | Component Name |
|---|---|
| 1 | Four Wheel Drive Switch |
| 2 | Transfer Case |
| Callout | Component Name |
|---|---|
| 1 | Steering Knuckle |
| 2 | Front Wheel Speed Sensor |
| 3 | Front Brake Rotor |
| Callout | Component Name |
|---|---|
| 1 | Brake Pressure Modulator Valve (BPMV) |
| 2 | Electronic Brake Control Module (EBCM) |
| 3 | Proportioning Valve |
| 4 | Master Cylinder |
| Callout | Component Name |
|---|---|
| 1 | Transmission Tunnel |
| 2 | Accelerometer Connector |
| 3 | Accelerometer |
| Callout | Component Name |
|---|---|
| 1 | Rear Brake Drum |
| 2 | Rear Wheel Speed Sensor |
| 3 | Rear Axle Housing |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
