2004 Chevrolet Tracker RWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. Install a stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary WindowsΒ .
  2. Install the windshield garnish molding to the vehicle. Ensure that the plastic retainers are completely engaged.
  3. Install the inside rearview mirror. Refer to Rearview Mirror ReplacementΒ .
  4. Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  5. Install the windshield wiper arms. Refer to Wiper Arm Replacement in Wipers/Washer Systems.
  6. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
  7. Fig 1: View Of Windshield, Male & Female Retainer Ends
    GM488769Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.