Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chevrolet Tracker RWDFACTORY OEM SERVICE PROCEDURE
A/C Compressor Control Module C2 Connector End View
A/C Compressor Control Module C2 Connector End View
| Connector Part Information |
|
|
|---|---|---|
| Pin | Wire Color | Function |
| 1 | PNK | A/C Compressor Relay Control |
| 2-3 | - | Not Used |
| 4 | YEL/BLK | A/C Idle-Up Control |
| 5-7 | - | Not Used |
| 8 | GRN/YEL | A/C Cut out Signal |
| 9 | - | Not Used |
| 10 | GRN/BLK | A/C Request Signal |
| 11-12 | - | Not Used |
| 13 | ORN | A/C Refrigerant Pressure Signal |
| 14 | - | Not Used |
| 15 | BLK | Ground G-103 |
| 16 | BLK/WHT | Ignition Positive Voltage |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
