2004 Chevrolet Tracker 4WDFACTORY OEM SERVICE PROCEDURE

Removal Procedure

    NOTE: This engine is equipped with an aluminum cylinder head. Allow the engine to cool before removing spark plugs. Removing the spark plugs from an engine at operating temperature may damage the spark plug threads in the cylinder head. Also be sure to clean any dirt or debris from around spark plug holes prior to removing spark plugs.
  1. Remove the two fasteners and the ignition coil cover (2) from the valve cover (1).
    2. Fig 1: View Of Ignition Coil Cover Fasteners & Valve Cover
    GM739064Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the ignition coil electrical connector.
  3. Remove the bolt (1) and the ignition coil (2) for each cylinder.
  4. Remove each spark plug (3) from the cylinder head.
  5. Inspect the condition of the spark plugs. Refer to Spark Plug Inspection .
    6. Fig 2: View Of Ignition Coil, Spark Plug & Bolt
    GM677343Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.