2004 Chevrolet Tracker 4WDFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
A/C Compressor Control Module Behind center of dash, on heater case. See Figure .
Daytime Running Lamps (DRL) Control Module Behind top left side of dash, right of steering column. See Figure .
Electronic Brake Control Module (EBCM) At left rear corner of engine compartment. See Figure .
Inflatable Restraint IP Module Right side of dash. See Figure .
Inflatable Restraint Sensing & Diagnostic Module (SDM) Below front center of console. See Figure .
Inflatable Restraint Steering Wheel Module On steering wheel. See Figure .
Inflatable Restraint Steering Wheel Module Coil Top of steering column. See Figure .
Powertrain Control Module (PCM) Under right side of dash. See Figure .
Remote Control Door Lock Receiver Above accelerator pedal. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.