2004 Chevrolet Tracker 4WDFACTORY OEM SERVICE PROCEDURE

ABS Component Views

Fig 1: Four Wheel Drive Switch Component View
GM419240Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Four Wheel Drive Switch
2 Transfer Case
Fig 2: Front Wheel Speed Sensor Component View
GM419248Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Steering Knuckle
2 Front Wheel Speed Sensor
3 Front Brake Rotor
Fig 3: EBCM/BPMV Assembly Component View
GM622806Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Brake Pressure Modulator Valve (BPMV)
2 Electronic Brake Control Module (EBCM)
3 Proportioning Valve
4 Master Cylinder
Fig 4: Accelerometer Component View
GM419256Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Transmission Tunnel
2 Accelerometer Connector
3 Accelerometer
Fig 5: Rear Wheel Speed Sensor Component View
GM419258Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Rear Brake Drum
2 Rear Wheel Speed Sensor
3 Rear Axle Housing
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.