2004 Chevrolet S10 PickupFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Safari and 2004 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the battery (2) with the positive (+) side down.

    Use one 3 V CR2032 battery (or the equivalent).

    Fig 1: View of Transmitter Battery & Case
    GM277192Courtesy of GENERAL MOTORS CORP.
  2. Close the transmitter case (6, 4).
  3. Ensure the seal is in position. Align the 2 halves of the case and snap the two halves together.
    Fig 2: View Of Transmitter Case
    GM296911Courtesy of GENERAL MOTORS CORP.
  4. Replace the batteries when the range of the transmitter decreases to less than 7 m (23 ft).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.