Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chevrolet S10 PickupFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Disconnect the negative battery cable.
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
- Drain the fuel tank. Refer to Fuel Tank Draining Procedure (2-Door Utility) .
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Clean all the fuel pipe connections and the surrounding areas before disconnecting in order to avoid possible contamination of the fuel system.
- Remove the fuel tank. Refer to Fuel Tank Replacement (Pickup) , Fuel Tank Replacement (2-Door Utility) or Fuel Tank Replacement (4-Door Utility) .
- Disconnect the rear fuel feed pipe from the fuel filter inlet.
- Disconnect the rear fuel return pipe from the chassis fuel return pipe (2).
- Remove the fuel feed and return pipes from the retainers.
- Cap the fuel pipes in order to prevent possible fuel system contamination.
CAUTION:
Refer to Battery Disconnect Caution in Cautions and Notices.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
