2004 Chevrolet S10 PickupFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
Automatic Transmission Control Module Connector On center of front floor pan. See Figure.
Body Control Module Under dash, on heater case. See Figure.
Body Control Module Connector Under dash, on heater case. See Figure.
Central Sequential Fuel Injection (4.3L VIN X) On top center of engine, forward of distributor.
Cruise Control Module (CCM) On left side of firewall. See Figure.
Cruise Control Module Connector Left side of firewall. See Figure.
Driver Information Center In front overhead console.
Electronic Brake Control Module (EBCM) Near left front inner fender, on brake pressure modulator valve. See Figure.
Electronic Brake Control Module (EBCM) Connector Left rear of engine compartment. See Figure.
Heated Seat Control Module (Driver/Front Passenger) Under respective front seat. See Figure.
HVAC Control Assembly In center of dash.
Ignition Control Module (4.3L VIN X) On top right side of engine. See Figure.
Inflatable Restraint I/P Module Right side of dash. See Figure.
Inflatable Restraint Module Connector Right side of dash. See Figure.
Inflatable Restraint Sensing & Diagnostic Module (SDM) Under console & carpet, between front seats. See Figure.
Inflatable Restraint Steering Wheel Module In steering wheel. See Figure.
Memory Seat Module (Driver) Under left front seat.
Powertrain Control Module (PCM) On right side of engine compartment. See Figure.
Remote Control Door Lock Receiver (RCDLR) Behind lower left side of dash. See Figure.
Sunroof Control Module At front of sun roof. See Figure.
Transfer Case Shift Control Module Behind right kick panel. See Figure.
Transfer Case Shift Control Module Connector Behind right front kick panel. See Figure.
Turn Signal Lamp/Hazard Flasher Module Behind right side of dash. See Figure.
Window Wiper Motor Controller-Rear Part of rear window wiper motor. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.