2004 Chevrolet Malibu BaseFACTORY OEM SERVICE PROCEDURE

Removal Procedure

    Fig 1: View Manifold Absolute Pressure (MAP) Sensor
    GM897270Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator ReplacementΒ .
  3. Remove the throttle body. Refer to Throttle Body Assembly ReplacementΒ .
  4. Disconnect the manifold absolute pressure (MAP) sensor harness connector.
  5. Remove the MAP sensor and the MAP sensor port seal if it is still retained in the intake manifold
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.