Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chevrolet Malibu BaseFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Record the preset radio stations.
- Turn the ignition OFF.
- Disconnect the negative battery cable.
- Engine Harness Connection (1).
- Battery Feed (2).
- Starter Motor (3).
- Starter Solenoid (4).
- Raise the vehicle.
- Remove the 2 starter solenoid harness connector attachment nuts.
- Remove the lower starter assembly to the engine block bolt.
- Remove the upper starter assembly to the engine block bolt.
- Move the starter right to clear the engine block, then left to remove the starter from the flywheel housing.
- Disconnect the CKP sensor harness connector.
- Remove the CKP sensor attachment bolt and the CKP sensor.
Fig 1: Disconnecting Engine Harness Connection, Battery Feed, Starter Motor And Starter Solenoid (2.2L)
CAUTION:
Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
