Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Install the PCM to the PCM electrical connectors.
Tighten: Tighten the connectors to 8 N.m (71 lb in).
- Install the PCM and the wiring harness to the air cleaner housing assembly (3).
- Install the air cleaner housing cover (1).
- Install the air cleaner housing cover screws (2).
Tighten: Tighten the screws to 4 N.m (35 lb in).
- Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
- Install the left front inner fender brace. Refer to Brace Replacement - Front Fender Upper Diagonal in Body Front End.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
- The new PCM must be programmed. Refer to Service Programming System (SPS) in Programming.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.