2004 Chevrolet Impala LSFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
A/C Compressor Clutch Diode In wiring harness, 10 cm from A/C compressor clutch.
Audio Amplifier In luggage compartment, beneath center of rear package shelf. See Figure.
Battery Right front of engine compartment. See Figure.
Battery Feed Rear compartment, above right wheelwell. See Figure.
Blower Motor Resistor Assembly On HVAC module, below blower motor.
Cellular Antenna On rear window. See Figure.
Cellular Antenna Coax Connector Above left side of package shelf. See Figure.
Data Link Connector (DLC) Below left side of dash, right of steering column.
Digital Radio Antenna Rear center of roof. See Figure.
Digital Radio Receiver In rear compartment, mounted to rear of right rear wheelwell.
Generator Connector (3.8L VIN 1) Upper rear of engine. See Figure.
Generator (3.4L VIN E) Right front of engine. See Figure.
Generator (3.8L VIN K) Upper right front of engine. See Figure.
Generator (3.8L VIN 1) Top right front of engine. See Figure.
Heated Seat Cushion Element Connector In seat cushion. See Figure.
Horn Assembly Lower right front of vehicle. See Figure.
Horn Assembly Connector Right front of engine compartment, behind front bumper. See Figure.
Ignition Coils On right side of engine. See Figure.
Inflatable Restraint Steering Wheel Module Coil In steering column, behind steering wheel. See Figure.
Inflatable Restraint Steering Wheel Module Coil Connector Lower center of instrument panel.
Navigation Antenna In passenger compartment, under left center of package shelf trim. See Figure.
Negative Battery Cable Right front of engine compartment. See Figure.
Positive Battery Cable Right front of engine compartment. See Figure.
Positive Battery Feed At back of starter. See Figure.
Positive Terminal Of Generator (3.8L VIN 1) At rear of generator. See Figure.
Starter Solenoid Lead Lower left front of engine (3.8L VIN K & VIN 1). See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.